Nokia LCD ways for how to jumper wire from board to LCD connector
 |
| Nokia 105 LCD ways |
Wednesday, September 23, 2015
BlackBerry Q10 LCD ways
Assess carefully on connector pin perhaps not on associated components in this sequence.
1. 2_2OLED_F to pin 28,30 2.2v.
2. 3_1OLED_F to pin 22,24 3.10v.
3. SYS_F to pin 3,5.(this is 3.6v battery volt.)
4. Datelines to pin 13,15,19,21,25,27.
5. LCD remainder to trap 31 via R2800 their should be 1.8v.
Just above pin employed by liquid crystal display.
Ensure your handset is fully in working in fully link adjust and pc. Its revealing red light simply.
you mentioned "after I eliminate the diode is heading to black display " before that you observed in in liquid crystal display in working fine?
1. 2_2OLED_F to pin 28,30 2.2v.
2. 3_1OLED_F to pin 22,24 3.10v.
3. SYS_F to pin 3,5.(this is 3.6v battery volt.)
4. Datelines to pin 13,15,19,21,25,27.
5. LCD remainder to trap 31 via R2800 their should be 1.8v.
Just above pin employed by liquid crystal display.
Ensure your handset is fully in working in fully link adjust and pc. Its revealing red light simply.
you mentioned "after I eliminate the diode is heading to black display " before that you observed in in liquid crystal display in working fine?
 |
| BlackBerry Q10 LCD WAYS |
Subscribe to:
Posts (Atom)
Lenovo A2010 Charging ways
Lenovo A2010 if you got charging and battery problem are pressist so you need this solution to rescue the lenovo mobile charging problem. T...
-
Nokia Lumia 1520 schematic service manual layout, If you can find Ics location, Network ics info, Antina ways, Mic ways, Speaker ways, Buz...
-
iPhone 4S Base band stop working, iPhone 4S no baseband / not working, U1001_RF damage alternative repair ways. If somebody not takes care...